Fairhope Drywall Repair Pros (251) 270-4751Open 7 days, 7am–9pm

Service

Seam, tape and crack repair for walls and ceilings in Fairhope

Seam, tape and crack repair in Fairhope comes down to telling a cosmetic crack from one that is reporting something. A hairline at a corner is usually just the house settling into the seasons. Tape that bubbles in a bathroom is usually moisture. A crack that runs diagonally from a door frame and keeps reopening is the framing moving. The three call for three separate repairs, so we read the crack before we fill it.

Patterns

Read the crack before filling it

Three common drywall crack shapes Three wall panels. The first shows a short hairline crack where a wall meets the ceiling at an inside corner. The second shows a diagonal crack running up and away from the top corner of a door frame. The third shows a straight crack running the length of a vertical seam, with a small blister in the tape. Corner hairlineSeasonal movement;usually cosmetic Diagonal from a doorStress at the header;check if it returns Straight along a seamTape bond failing;check for moisture
Direction and location tell you more than width. A seam crack is a tape problem; a diagonal one points at framing.

The drawing shows the three shapes we see most. Location and direction say more than width does. A crack that runs exactly along a seam is a tape problem. One that starts at the corner of a door or window and runs at an angle sits where stress collects in the wall. A crack in the middle of a sheet, away from any seam or opening, is less common and worth a closer look at the framing behind it.

Humidity

Check the moisture before blaming the house

Fairhope sits on the eastern shore of Mobile Bay, and the long, humid summers are hard on joint tape. Paper tape is held on by the compound under it. When a bathroom without a working fan steams up every morning, or air conditioning cycles a room between damp and dry, that bond weakens and the tape lifts in a blister or a long ridge.

So the first check is moisture: a meter reading on the seam, a look at the bath fan and whether it actually vents outside, and whether the problem sits on an exterior wall. Fixing the tape without fixing the damp just gives you the same ridge next summer.

FAQ

Sort out crack and tape questions

Why does a filled crack come back in the same spot?

Filling without tape leaves nothing to bridge the movement. If it returns even after taping, the wall is still moving, often at a door or window header, and that needs checking.

What makes joint tape bubble?

Usually moisture weakening the bond under the tape, or tape that was bedded with too little compound when the wall was first finished. Bathrooms and exterior walls show it most.

Can the texture on my wall be matched?

In most cases. Orange peel, knockdown and smooth finishes can be rebuilt over the repair and blended into the surrounding wall before priming.

House age

Factor in how the house was built

Fairhope's housing covers a long span. In the Montrose Historic District, whose National Register listing dates to 1976, some cottages date to the middle of the 1800s and have been remodeled several times, so a seam can be the joint between original material and board added much later. Those joints move differently and need tape and compound that can handle it.

In the newer subdivisions, the common complaints are nail pops and seams that show through paint in raking light, often where framing lumber dried and shrank after the board went up. A popped fastener gets reset with a screw beside it, and the old one is driven below the surface and covered.

The fix

Retape rather than recoat

A fresh coat of compound over loose tape only masks the ridge until the next humid stretch. We slice away every strip that has lifted, back to where it is firmly attached, scrape away the failed compound, and embed new tape using a setting-type mud, which sets harder and is less bothered by humidity than ready-mix. Then two finish coats feathered wide, sanding, and primer.

Diagonal cracks at door and window corners get the crack opened into a shallow V, tape or mesh laid across it, and the coats spread well past both ends. If the crack keeps returning, we check the door header and whether the door binds, since that points to movement that compound alone won't hold.

Related

See the neighboring repairs

When a seam lifted because of a leak rather than everyday humidity, the work starts on the water and storm damage page. Cracks that ended in a broken corner or a hole are covered under hole patching. Check the service-area list for your town, then tell us where the crack runs.

Next step

Book a moisture check for this wall

Phone the shop, text over a picture, or fill in the contact page. Say where the damage is and what you think started it.

(251) 270-4751

Open 7 days, 7am–9pm

Text a photo any time to the same number; it is read during open hours.